Designing the Display Window: Tolerances, Tinting and Assembly
Most "display problems" reported on a production line are window problems. How to specify the aperture so the display lands correctly every time.
Read moreInsights
How MOQ and Tooling Shape the Price of a Custom Display
Why the same drawing gets quoted at two very different prices, and how to structure a first order so the unit price is not the only…
Read more
What Makes a Display Readable in Direct Sunlight?
Brightness is the wrong answer to sunlight. Contrast, reflectance and polarizer choice decide whether a display survives a bright day.
Read more
Segment LCD vs Dot-Matrix vs TFT: Which One Does Your Product Need?
Three display technologies, three very different cost and firmware profiles. A decision order that avoids the two most expensive mistakes.
Read more
Wide Temperature LCD Displays: What -30 °C to +80 °C Really Requires
A temperature range on a datasheet is easy to print. Here is what actually has to change in the display, the backlight and the test plan…
Read more
Why Water Meter Displays Fail in the Field (and How to Specify Against It)
Six failure modes that show up years after installation, and the specification choices that prevent them.
Read more
How to Choose a Segment LCD Display for Your Meter Design
A practical sequence for meter designers: start from how the product is used, then work through mode, duty, temperature, connector and validation.
Read more
FPC vs Metal Pin vs Zebra Connector: Choosing the LCD Interface
The three ways to connect a segment display to your board, and how to choose between them based on assembly, serviceability and cost.
Read more
Custom Segment LCD Tooling: What It Costs and How Long It Takes
Tooling is the one-off cost that turns a drawing into a producible display. What drives that cost, what the timeline looks like, and how to reduce…
Read more
What Duty and Bias Mean in a Segment LCD (and Why It Changes Your Driver)
Duty and bias decide how many segments one controller can drive and how sharp the display looks. The practical explanation, without the datasheet language.
Read moreRequest a quotation
Send your drawing, target quantity and operating conditions. Our engineers reply with a feasibility check, tooling cost and lead time within one business day.
- Drawing review within 24 hours
- Samples in 7–10 working days
- NDA available on request